Dual H Bridge DC Stepper Motor Drive Controller Board Module Arduino L298N HE
Dual H Bridge DC Stepper Motor Drive Controller Board Module Arduino L298N HE.



Product Description

  1. L298N as main chip,
  2. Low heat,outstanding anti-interference performance.
  3. High working power to 46v,large current can reach 3A MAX and continue current is 2A, power to 25w.
  4. Can drive one 2-phase stepper motor.
  5. one 4-phase stepper motor or two DC motors.
  6. Built-in 78M05,
  7. Get power from drive power,however, when drive power over12V, please use the external 5v power as power supply.
  8. Large capacity filter capacitance,afterflow protection diode, more stable and reliable.

Logical voltage: 5V
Drive voltage: 5V-35V
Logical current: 0mA-36mA
Drive current: 2A(MAX single bridge)
Max power: 25W


This module has a built-in 5v power supply, when the driving voltage is 7v-35v, this supply is suitable for power supply
DO NOT input voltage to +5v supply interface, however ledding out 5v for external use is available.
When ENA enable IN1 IN2 control OUT1 OUT2
When ENB enable IN3 IN4 control OUT3 OUT4

Additional Information

Weight 26 g
Dimensions 43 x 43 x 30 mm


There are no reviews yet.

Be the first to review “DC STEPPER MOTOR DRIVER”

  • Selection Required: Select product options above before making new offer.
  • Offer Sent! Your offer has been received and will be processed as soon as possible.
  • Error: There was an error sending your offer, please try again. If this problem persists, please contact us.

Make Offer

To make an offer please complete the form below:

Please wait...